![]() ![]() ![]() I've also removed the Flic app from all devices, and reinstalled it. I have an iPad and Apple TV (also latest TvOS) configured as Home hubs. The Flic connected to the hub does show up as a binary object but has a permanent on state. I have the latest iOS (15.x) installed on both iPhone and iPad. I have another Flic this time connected to the Flic hub. I've also tried to add a new home in the Apple Home app. There is no mention of Apple Home in the Flic app settings either. Using Flicd addon didn't give a stable integration, but this is a workaround I've found was quite stable. samjay I had the same issue, I removed the hub from Apple Home, then reset the Flic Hub, then went through the entire process of setting up the hub and then setting up the Flic button. The firmware upgrade is successful (3.0.12), but when I try to "Add to homekit" from the button configuration, the hub (and button) is not seen by HomeKit/Apple Home, and I never get any notifications regarding the Flic Hub requiring access to Homekit or network (that only happened once, the first time I went through this setup). Is Flic Hub LR compatible with Home Assistant Flic Hub 1 1 433 Log in to reply rynemark, 14:37 The Hub is working, Home Assistant working, adding the required stuff at binarysensor. 1 c 0, 10:35 I know your post is old, but I've been struggling too with connecting Flic 2 and Home Assistant. Then I add a Flic 2 button and receive a message saying the hub's firmware needs to be upgraded, which I do. I’ve had a few requests for a step by step guide to setting up Flic Hub to send requests into home assistant. I have reset the hub at least 50 times (pin hole button, 13-15 seconds) and the hub is resetting OK. Input your destination, and set the navigate type (drive, public transportation, bicycle or walk). 4 Likes Flic Hub SDK -> Web Hook (step by step) Direct Flic Button via Flic Hub MQTT integration - Cloudless Flic Hub SDK -> Web Hook (step by step) erwin. The only thing you need to think about is where you want to go. The ‘from’ position is your current location. ronsell I had the same issue, I removed the hub from Apple Home, then reset the Flic Hub, then went through the entire process of setting up the hub and then setting up the Flic button. I have tried to re-add my Flic LR hub (and Flic 2) since october without any luck. This function allows you to start your phone’s navigation system with a press of the Flic button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |